Fitting Kit

Defi-Link Fitting Kit is to mount a gauge on an A-pillar or a steering column. This product is for 2 1/16″(52mm), 2 3/8″(60mm) gauges. Mounting angle is flexible.

Fitting Kit
Pats No. DF09501
Applicable products ADVANCE gauges 52/60
ADVANCE FD
ADVANCE ZD
Racer Gauge Style98 Hommage 60
Racer Gauge N2+ 52/60
Racer Gauge N2 52/60
Racer Gauge 60

*The mounting bracket for the former Defi-Link series was also included in the package until June 2023 shipment, but only one mounting bracket for both ADVANCE series and Racer Gauge series (except early 52mm models) is included in the package from July 2023 shipment.

Component

Component

How to attach

How to attach
  1. Remove the plastic parts to which this fitting kit will be attached, such as an A-pillar or steering column.
  2. Drill a Φ4.5mm pilot hole in the removed plastic part. (Fig. 1)
  3. With the mounting rubber set on the mounting bracket, secure it in place using two M4×12 screws and two nuts. (Fig. 1)
  4. Attach the removed plastic part.
  5. Place the protruding part of the mounting bracket in the groove of the gauge cup, and secure it in place using one M4 screw and one nut. (Fig. 2)
  6. Follow the gauge instruction manual for installing the gauge body and gauge cup.

Caution

  • This product cannot be installed on vehicles equipped with front or curtain side airbags.
  • Install this product in a position that does not interfere with driving.
  • Take care not to pinch the wiring in the vehicle body or threaded parts.
  • When using this product, be sure to also read the instruction manual for the gauge.