|
|
|
TROUBLE SHOOTING
|
|
Please refer to the table below and reconfirm before asking for
repair.
|
CONDITION
|
*The gauge shows low value in general.
*When ignition is on, the zero point slips out of position. |
|
POSSIBLE CAUSE
|
*The ground wire is not properly fixed on the earth.
*Any harness wire is not installed properly. |
|
REMEDY
|
*Extend the ground wire of the power wire and connect it properly
to the battery minus terminal.
*Check wiring. |
|
CONDITION
|
*The warning LED lamp flashes ON at a value different from
the set warning value.
*The pointer is showing an abnormal value. |
|
POSSIBLE CAUSE
|
| *Various harnesses are picking up
noise from spark signal or wireless
radios, etc. |
|
REMEDY
|
| *Reposition the signal wire avoiding noise. |
|
CONDITION
|
| *The warning LED lamp is flashing ON and OFF. |
|
POSSIBLE CAUSE
|
*There is a wire short circuit somewhere.
*There is a wire broken, or disconnected.
*Set the wrong cylinders number. |
|
REMEDY
|
*Confirm that no wires are touching the vehicle body.
*Confirm that there are no wire broken or the connectors are
not disconnected.
*Confirm that the setting of cylinders number is correct. |
|
|
End
of Life Products |
