| 1. Install gauges |
| Fit gauges into the holes of the hood and push
rubber-boots on gauges from the backside of the hood. |
|
 |
 |
Clear away dirt from the gauge. |
|
Push the rubber-boots tightly on the back of the
face panel. |
| 2. Dismantle the clock hood |
| Remove the clock hood from the instrument panel.
Please mind that the clock hood has six hooks. Disconnect the
clock wire connector. |
 |
|
|
The clock wire has to be fixed somewhere to avoid
noise and short circuit. |
| 3. Install the Triple Meter
Hood |
| Install the Triple Meter Hood with gauges where
the clock hood was originally placed. |
|
|
|
Hooks may be broken if the excessive force is
applied, so please be careful when installing. |
| 4. Attach the Defi emblem |
Attach the Defi Emblem anywhere you like.
|
| PAINTING |
| 1. |
The Triple Meter Hood Surface is undercoated.
Please file the surface smooth gently with sandpaper(#800 or
finer one) before painting. |
| 2. |
If you require better surface finish, please dismantle
six screws from the backside of the Triple Meter Hood. Then
paint the face panel and the hood separately. After the paint
gets dry completely, please reassemble the screws and the hood.
(Recommended tightening torque is between 50N and 80N.) |
|
|
Do not file the surface too much. |
|
Paint for plastic must be used. |
End
of Life Products |
The
TRIPLE METER HOOD allows Defi-Link Meters and Defi-Link Meter BFs
to be mounted on Subaru New Age Impreza.
