| Special Display Mode |
This screen is displayed when speed is 0km/h or 0MPH for more than
10 seconds.
*Turbo Meter and Tachometer are not displayed. |
 When
Special Display is turned on in Set Up Mode, thepeak values for meters
having connected sensors are displayed from the time ignition is on
while in Gauge Mode or Speed Mode. |
 When
special Display is turned off in Set Up Mode, the digital display
disappears and the Warning LED flashes at a steady interval. |
| Warm-up
Mode |
This screeen monitors water temperature until it reaches a set
value.
|
When Warm-Up is turned on in Set Up Mode and the water temperature
sensor is connected to Control Unit II or Control Unit, the Warm-Up
Mode activates after Opening Mode is completed. The "Warm-up"notice
and current water temperature are displayed until the temperature
reaches the set value.
When the temperature reaches the set value, the warm-up completed
“Readyƒ notice is displayed for 5 seconds and the unit returns
to the display mode used before the ignition was turned off (Speed
Mode, Gauge Mode or Triple Warning Mode). Factory setting is Gauge
Mode.
|
 *REC,
PLAY and PEAK display cannot be used during
Warm-up Mode.
|
 Water
temperature of 20oC (68oC) or below is displayed as "-
- -".
|
 |
If the MODE SELECT button or SET UP button is pressed before
water temperature reaches the set value, the unit will switch
to the other mode (except for Warning Setup Mode or Set Up Mode)
and a "C" symbol will appear in the upper left corner
of the screen until the temperature reaches the set value.
*REC, PLAY and PEAK display can be used while the "C"
symbol is displayed |
|
| Self-Diagnosis
Function |
| This screen displays serial errors, opens and shorts for each sensor
of meters connected to Defi-Link Control Unit II or Defi-Link Control
Unit when ignition is on. If an error message is displayed, check
the item and take appropriate actions.) |
| 1. Serial Error Function |
 |
This function notifies of communications
that have been interrupted beteween the meter and the Control
Unit. |
|
| 2. Disconnection(Open)Check
Function |
 |
This function notifies that a
wire distuption, disconnection or improper wirin gconnection
has occurred at the sensor or in the sensor wire. |
|
| 3. Short Curcuit Check
Function |
 |
This function notifiies that
a short circuit has occurred somewhere at the sensor or in the
sensor wire. |
|
| |
| Opening
Mode |
This screen appears when the ignition is turned on.
 |
Factory setting is for switch
to Warm-up Mode after Opening Mode is complete. |
|
| Ending
Mode |
This screen appears when the ignition is turned
off.
 |
Factory setting is for switch to Warm-up Mode
after Opening Mode is complete. |
|
 CLOSE
|