Defi Homepage
Home Club Defi Products Lineup Parts List Catalog Japanese Site
Contact Information Shops List Overseas Distributors
PRODUCTS
Defi-Link VSD X Defi-Link Meter BF Defi-Link Display Defi-Link Control Unit II  
Racer Gauge BF Tachometer Meter Hood & Option DIN-Gauge  
 
End of Life Products | Defi-Link Meter | VSD BASIS | VSD CONCEPT |
Defi-Link Display
PRODUCT FEATURES
SPECIFICATIONS
FEATURES OF
DEFI-LINK SYSTEM
SAFETY WARNING
PARTS LIST
HOW TO INSTALL
HOW TO OPERATE
TROUBLE SHOOTING

HOW TO INSTALL

Carefully read the "Safety Warning" section of the manual concerning installation and operation. Then install the product properly and safely.
Installation in an unsuitable location or improper installation can result in the product falling from its position or damage to the vehicle.


Be sure to connect the speed signal wire to this product. If the speed signal wire is not connected, the display will stay in the Special Display Mode.
Although the speed signal wire is included in the kit, each sensor and sensor wire are set up as option parts.
When Defi-Link Display is connected to Defi-Link Meter BFs, Triple Warning Mode cannot be used.
The Defi-Link Display will not operate without connection to Defi-Link Control Unit II or Defi-Link Control Unit.
When Defi-Link Meters or Defi-Link BF Meters are connected, a maximum of 7 components can be connected, including Defi-Link Display.
See the Defi-Link System operations manual for installation of Defi-Link sensors.
Only the Speed Mode will be shown on the Defi-Link Display when no other sensors are connected to Defi-Link Control Unit II or Defi-Link Control Unit. In that case, PEAK Mode and REPLAY Mode will not be available.
Be sure the speed signal wire is connected when using this display.

When connected to Defi-Link Control Unit II
The display can be connected to any of Defi-Link Control Unit II(see figure below), Defi-Link Meter and Defi-Link Meter BF. Switching the lighting between the daytime mode and nighttime mode is interlocked with the illumination switch of the vehicle.

When installing or working with the display, be sure to follow the applicable instructions for either Defi-Link Control Unit II or Defi-Link Control Unit as shown in their corresponding manuals.
Installation in an unsuitable location or improper installation can result in the product falling from its position or damage to the vehicle.



When connected to Defi-Link Control Unit
The display can be directly connected to either the Control Unit(see figure below) or Defi-Link Meters.




Installing the Mounting Bracket
1. Cut the supplied double-sided tape.[Figure1]
2. Insert the protrusions of the mounting bracket into the slots of the meter holder, then secure with the supplied bolt and nut. [Figure2]
3. Attach the supplied double-sided tape to the underside of the mounting bracket. Align the mounting bracket with the location for unit installation, then bend the mounting bracket to the shape of the location while pressing down so the tape will adhere. To prevent the unit from falling off, secure the mounting bracket with commercially available self-tapping screws.




Before attaching the mounting bracket to the dashboard, thoroughly clean the mounting surface with a commercial dashboard cleaner to remove dust, dirt and oils.
Installation in an unsuitable location or improper installation can result in the product falling from its position or damage to the vehicle.

Adjusting the height of the installation stay

Turn the set screw to adjust position on the installation stay so the display is easy to see. (Position can shift up or down by 9.5mm.)

Be sure to secure the installation stay in place with the set screw. If the screw is tightened up without the stay being placed between, it can damage the parts and cause failure of the product.