 REAL
MODE
The pointer displays the actual engine speed in time. At the
same time, the PEAK value is stored in memory inside the control
unit.
|
PEAK
MODE
If PEAK switch is pressed for less than 2 seconds, the PEAK
LED is illuminated. This indicates PEAK MODE. The control unit
records any new PEAK values as this occur(The memory function
is active even if the vehicle key is switched OFF. Values stored
in memory are not lost). If the PEAK switch is pressed again
for less than 2 seconds, the system will return to REAL MODE.
|
RESET
MODE
If PEAK switch is pressed continuously for more than 2 seconds,
the PEAK LED(green lamp) is lit for a while and then flashes.
Reset is complete after above procedure. If the switch is released,
Tachometer will return to REAL MODE.
*Reset is possible from either REAL MODE or PEAK MODE.
|
WARNING SET MODE
If SET select switch is pressed, WARNING LED(red) will show.
This is the WARNING SET MODE. Press the 
switch or 
switch to increase or decrease the warning set value.
*Pressing the switch continuously will cause the needle to move
continuously.
*After setting the values and the switch is not pressed for
more than 5 seconds, WARNING LED(red) lamp switches off. Setting
is completed and Tachometer returns to REAL MODE.
It is very dangerous to set gauges while driving. Please set
while the vehicle is stopped.
|
| CHECK FUNCTION |
|
|
OPENING
MODE
It is possible to confirm the performance of the Tachometer
by the movement of the pointer, PEAK LED and WARNING LED.
|
CYLINDER
NUMBER SETTING ERROR CHECK
This function is meant to report any case of engine cylinder
numbers setting error. The pointer points downwards and
the WARNING LED flashes at the same interval.
|
SERIAL
ERROR CHECK
This function is meant to report any case when communication
between the Tachometer and the control unit fails. The
pointer points downwards and the WARNING LED flickers
on and off twice at the same interval.
|
|
End
of Life Products |
