|
|
|
How to connect the wires
for your vehicle type
|
*Find the ignition switch connector, referring to the "Position
of the ignition switch connector" below.
* Pull out the ignition switch connector, referring to the "Ignition
switch wiring" below. Connect the appropriate wires for your
type of vehicle to the connector which is the nearest one to the key
cylinder.
* Joint a connector from the appropriate wires for your type of vehicle
and a connector from the control unit of the After Idle Timer.
| (1)The ignition switch connector
is located on the back side of the switch (in the steering column).
|
(2)The ignition switch connector
is located in the dashboard. |
Manufacturers:
Nissan
Honda
Daihatsu
Suzuki |
Manufacturers:
Toyota
Mitsubishi
Nissan
Mazda
Subaru |
|
|
Wiring between the control
unit of After Idle Timer and Boost V.S.D.
|
*Check the upper and lower sides of the 9P connector from the control
unit of After Idle Timer.
Insert the 9P connector securely in the socket of the control unit
of the Boost-V.S.D.
 |
 |
When removing the connector, do not pull on the tube. Hold
the wires and pull gently. |
|
|
How to wire the parking
brake
|
This control unit detects the condition of the parking brake and
suspends the operation of the timer in the following situations ;
*If the parking brake is not set, the timer does not function.
*If the parking brake is released during the operation of the timer,
the timer is turned off.
 |
If there is only one wire to the parking brake; |
| |
1. Remove any covers so that the parking brake
switch is accessible.
2. As there is a wire from the parking brake switch, connect
the blue wire from the After Idle Timer to that wire with a
solderless connector. |
|
If there are two wires to the parking brake; |
| |
1. Push on the brake pedal when the ignition is
turned off.
2. Holding the brake pedal and using a volt meter, locate a
wire that reads 12V when the parking brake is released and that
reads about 0V when the parking brake is set.
3. Connect blue wires from the After Idle Timer to the wire
located above with a solderless connector.
Note: If your parking brake is located on the steering column
or a pedal type brake, the same wiring procedures apply. |
|
|
FINAL INSPECTION AFTER
INSTALLATION
|
After installation, please perform the following tests;
|
AUTO MODE TEST
*Set the Auto mode to the preferred mode.
*Confirm that the timer begins to count down when the ignition
key is turned OFF and that the engine turns off when the count
reaches "0.00". |
|
MANUAL MODE TEST
*Set the after idle timer to the Manual mode.
*Turn the ignition key to ON and set the after idling time.
*Confirm that the after idle timer starts the countdown when
the ignition key is turned OFF and that the engine turns off
when the count reaches "0.00". |
|
PARKING BRAKE TEST
* After setting the parking brake, turn the ignition key ON
and hold the ignition key ON for a few seconds.
*If the timer starts a countdown when the ignition key turned
OFF, release the parking brake and confirm that the engine turns
off. |
|
End
of Life Products |
