|
|
|
|
|
The Boost V.S.D. kit comes with the following parts. Please confirm
that all parts listed below are included in the package. In case
a part is missing or defective, please contact us at 
for a replacement part.
|
|
Part Name
|
Quantity
|
|
Display Unit (5ft. wire)
|
1
|
|
Control Unit (3 1/3ft. wire)
|
1
|
|
Base(Stand for the display unit)
|
1
|
|
Display Film
|
2
|
|
Adhesive Tape ( 2 3/4 in. x 1 4/5 in.)
|
1
|
|
Solderless Connectors(Elector tao)
|
3
|
|
Tie Wraps
|
2
|
|
Clamps
|
1
|
|
Pressure Sensor
|
1
|
|
Rubber Hose(1 3/5ft.)
|
1
|
|
Three Way Connector
|
1
|
|
Screw (to attach the sensor)
|
1
|
|
Installation Manual
|
1
|
|
|
|
|
|
|
|
|
|
| 1. |
Attach the sensor in a location where there is
as little vibration as possible and in a position where it can
be isolated from the engine heat. The tubing should be kept
as short as possible. |
| 2. |
The vacuum pressure measured at a point between
the intake manifold and the fuel pressure regulator. |
| |
1) |
Detach the vacuum hose from the side of the intake
manifold that has
fewer pressure fluctuation's motion, and connect it to the three
way
connector "b" (or "a"). |
| |
2) |
Cut the required length of the tubing from the
kit and use it to connect
the intake manifold to the three way connector "a"
( or "b"). (If the diameter of the tubing does not
match that of the intake manifold,
please cut and use part of the vacuum hose.) |
| |
3) |
Use the remaining tubing to connect the sensor
to three way connector "c". |
|
|
|
| Power
Supply Voltage |
DC10V to 15V
(for use 12V Vehicles Only) |
| Current
Consumption |
Max. 0.5A |
| Operating
Temperature |
-14oF to +140oF
(humidity below 80%) |
|
| Storage
Temperature |
-22oF to +176oF
(humidity below 80%)
|
|
| Display
Range |
Gasoline
Turbo |
-760mmHg to 1.6kg/cm2 |
| Diesel
Turbo |
0 to 1.6kg/cm2 |
| Gasoline |
-760 to 0mmHg |
| Dimensions
(inch) |
Display
Unit
(including stand) |
3 1/3(W) x 1 5/6(D) x 4/5(H) |
| Control
Unit |
3 9/10(W) x 2 4/7(D) x 1 1/15(H) |
| Gross
Weight |
2/3 lb
(including Display unit, control unit, stand, Pressure Sensor
and wires) |
|
|
End
of Life Products |
